THORLABS DCC1645C - Is_Stealvideo

© 2013 Thorlabs GmbH
4 Programming (SDK)
447
4.5.48 is_StealVideo
USB 2.0
-
Syntax
INT is_StealVideo (HIDS hCam, INT Wait)
Description
Attention
This function is obsolete and should not be used anymore. We recommend to use the is_DirectRenderer()
function instead (see also Obsolete functions ).
Using is_StealVideo(), you can initiate the extraction of an image from the DirectDraw image data stream.
The extracted image is written to the active image memory. The data includes the color format set with the
is_SetColorMode() function.
You can use the is_PrepareStealVideo() function to specify to remove the image from the DirectDraw
data stream or to copy it. If you set the copy option, the image will both be displayed using DirectDraw and copied
to the currently active image memory.
See also the Events in Live Mode figure in the Event handling section.
Attention
This function is not supported in Direct3D mode.
Input parameters
hCam
Camera handle
Wait
IS_WAIT
The function waits until the image save is complete.
IS_DONT_WAIT
The function returns immediately.
Return values
IS_SUCCESS
Function executed successfully
IS_NO_SUCCESS
General error message
Related functions
is_PrepareStealVideo()
is_SetDisplayMode()
is_SetColorMode()
is_AllocImageMem()
is_SetImageMem()
is_SetAllocatedImageMem()
198 379
319
402
141
402
322
319
157
337
301