THORLABS DCC1645C - Is_Setgainboost

© 2013 Thorlabs GmbH
4 Programming (SDK)
331
4.3.85 is_SetGainBoost
USB 2.0
USB 3.0
USB 2.0
USB 3.0
Syntax
INT is_SetGainBoost (HIDS hCam, INT mode)
Description
In some cameras, is_SetGainBoost() enables an additional analog hardware gain boost feature on the
sensor.
Input parameters
hCam
Camera handle
mode
IS_GET_GAINBOOST
Returns the current state of the gain boost function.
IS_SET_GAINBOOST_ON
Enables the gain boost function.
IS_SET_GAINBOOST_OFF
Disables the gain boost function.
IS_GET_SUPPORTED_GAINBOOST
Indicates whether the camera supports a gain boost
feature or not.
Return values
Current setting when used together with
IS_GET_GAINBOOST
Returns IS_SET_GAINBOOST_ON if the function is
enabled, otherwise it returns
IS_SET_GAINBOOST_OFF.
Current setting when used together with
IS_GET_SUPPORTED_GAINBOOST
Returns IS_SET_GAINBOOST_ON if the function is
supported, otherwise it returns
IS_SET_GAINBOOST_OFF.
IS_INVALID_CAMERA_HANDLE
Invalid camera handle
IS_INVALID_MODE
Camera is in standby mode, function not allowed
IS_NO_SUCCESS
General error message
IS_SUCCESS
Function executed successfully
Related functions
is_SetHardwareGain()
is_SetHWGainFactor()
is_SetAutoParameter()
333
335
303