1-16
Twist Owner’s Manual
OM_TWIST_0811RevA
CHAPTER 1: WARNINGS
M. FASTENERS
I WARNING
TiLite uses only high-strength, high-quality fasteners (nuts, bolts, screws and clamps) on its wheelchairs. If you
replace any of these fasteners with improper or inferior fasteners, you may damage your chair or may cause it to fail
unexpectedly.
1. ALWAYS use fasteners obtained from an authorized TiLite dealer.
2. REGULARLY inspect all fasteners to make sure they have not become loose. If any become loose, tighten them
immediately.
3. NEVER over-tighten or under-tighten the fasteners on your chair. Over-tightened or under-tightened fasteners
may damage your chair or fail unexpectedly.
If you ignore these Warnings, you may fall, tip over or lose control of the wheelchair and seriously injure yourself or
others or damage the wheelchair.
N. UNAUTHORIZED PARTS AND ACCESSORIES
NEVER use parts, accessories or adapters other than those authorized by TiLite. If you have any doubt about the
compatibility of a particular part, accessory or adapter, consult with an authorized TiLite dealer or contact TiLite
Customer Service.
If you ignore these Warnings, you may fall, tip over or lose control of the wheelchair and seriously injure yourself or
others or damage the wheelchair.
To Next Page
Loading...
