TiLite Twist - Disengaging; Adjusting

13-3
Twist Owner’s Manual
OM_TWIST_0811RevA
CHAPTER 13: ANTI-TIPS
Disengaging
To disengage the anti-tip, grip the anti-tip rmly, pressing down on the release lever, raise the anti-tip until the anti-tip
receiver re-engages in the anti-tip mount in the “up” position shown in Figure 13-4.
Figure 13-4
Disengaging the Anti-Tip
Adjusting
To adjust the height of the anti-tip, press the two release buttons on the telescoping lower tube and adjust the height
of the lower tube so that the wheel is within 1-1/2” to 2” off the ground. See Figure 13-5.
Figure 13-5
Adjusting the Anti-Tip
Anti-Tip
Mount
Release Button
Receiver
Upper Tube
Lower Tube
Release Button