TiLite Twist - Changing the Back Angle

4-2
Twist Owner’s Manual
OM_TWIST_0811RevA
CHAPTER 4: BACKRESTS And PUSH HAndLES
Nylock Nut
Pivot Bolt
Figure 4-2
Adjusting the Back Mount
Changing the Back Angle
Tools Needed:
• 7/16” Open End Wrench
• 1/2” Open End Wrench
• 1/8” Allen Wrench
1. On each side of the chair, using the Allen wrench, remove the Buttom Head Cap screw and lock washer. See
Figure 4-3.
2. On each side of the chair, using the Open End wrenches, loosen but do not remove the stop bolt and nylock nut.
3. Adjust the backrest to the desired angle. On one side of the chair, while holding the backrest in place, align one
of the ve holes in the backrest cam with one of the three holes in the back mount. Place the Button Head Cap
screw through the lock washer, the backrest cam and into the back mount. Securely tighten.
4. Securely tighten the stop bolt and nylock nut.
5. Repeat Steps 3 and 4 on the other side of the chair.
Figure 4-3
Changing the Back Angle
Backrest
Nylock
Nut
Back Mount
Backrest
Cam
Lock Washer
Button Head Cap Screw
Stop Bolt