TiLite Twist - Flip-Back Tubular Armrest; Adjusting the Armrest Height

5-3
Twist Owner’s Manual
OM_TWIST_0811RevA
CHAPTER 5: ARMRESTS
Figure 5-4
Removable Desk Arm
Figure 5-5
Mounting Desk Arm
Armrest
Height
Adjustment
Lever
(locked)
Desk Arm
Housing
Release
Lever
Release
Lever
Desk Arm
Housing
Desk Arm
Mount
Height
Adjustment
Lever
(unlocked)
Flip-Back Tubular Armrest
To ip back the armrest, raise the front of the armrest and rotate it straight back as far as possible. Reverse this
procedure to return the armrest to its original position. See Figure 5-6.
Figure 5-6
Flip-Back Armrest
Adjusting the Armrest Height
Tools Needed:
• 3/16” Allen Wrench
1. Loosen but do not remove the two Allen screws securing the armrest clamp to the backrest. See Figure 5-7.
2. Loosen but do not remove the locknut which secures the pivot bolt.
3. Slide the armrest to the desired height on the backrest.
4. Securely tighten the Allen screws and locknut.
5. Follow Steps 1 through 4 on the other side of the chair. Make sure the armrest is set at the same height on both
sides of the chair.