TiLite Twist - Page 30

2-2
Twist Owner’s Manual
OM_TWIST_0811RevA
CHAPTER 2: SAFETY INSPECTION, MAINTENANCE &
TROUBLESHOOTING
Inspection Item Initially Weekly 3 Months
Rear Tires
• Check for proper ination as per sidewall of pneumatic tire
• Inspect for cracks, wear and at spots
√
√
√
√
Camber Tube/Axle Sleeves
• Make sure camber plug clamps are securely tightened
• Make sure camber plugs are secure in camber plug clamps and
axle sleeves are secure in camber plugs
√
√
√
√
Handrims
• Inspect for signs of rough edges or peeling
• Make sure handrims are securely attached to rim
√
√
√
√
Wheel Locks
• Make sure wheel locks embed proper distance into tire and
prevents chair from moving when engaged
• Make sure wheel locks do not interfere with tire when disengaged
• Make sure pivot points are free of wear and looseness
√
√
√
√
√
√
Seat Sling and Back Upholstery
• Inspect for rips or sagging
• Inspect fastening aps to ensure they are securely attached
• Inspect while seated to ensure sling supports your weight and does
not touch crosstubes
√
√
√
√
√
√
Casters/Forks
• Inspect wheels and tires for cracks and wear
• Inspect wheel/fork assembly for proper tension by spinning caster
(caster should come to a gradual stop); if caster wobbles, tighten
axle; if caster binds to a stop, loosen axle
• Inspect wheel/fork assembly/stem bolt to ensure that stem bolt
is secure (wheel/fork assembly should not have excessive play
relative to the stem bolt but should rotate freely); if necessary,
tighten stem bolt
• Ensure that wheel bearings are clean and free from moisture
• If pneumatic, check for proper ination as per the sidewall
√
√
√
√
√
√
√
√
√
√
Armrests
• Inspect to ensure that all hardware is securely attached √
√
Footrests/Hangers
• Inspect to ensure that all hardware is securely attached √ √
Anti-Tips
• Inspect anti-tip wheel for cracks and wear
• Inspect to ensure that anti-tip receiver is securely attached
√
√ √
√
Frame
• Inspect for cracks √ √