TIM MIRUS Controller - Responsibility of the Manufacturer; Safety Features

2 Safety
12 IFU, MIRUS Controller, en-GB, N.00
2.1.5 Responsibility of the manufacturer
The manufacturer is not responsible for any functional change of the device, damage or injury
to patient or operator that is caused by misuse or by disregard of the safety advice given in
this instruction for use.
The user or owner is responsible for the proper operation of the system, if the device is
serviced, maintained or repaired by unauthorised personnel.
The user or owner is responsible for the proper operation of the system if the device is misused
or not used according to the instructions given in these instructions for use.
2.1.6 Safety features
The following safety features are built into the MIRUS Controller to warn the operator in case
of hazard to the patient.
Device alarms
Control of
Control for
Anaesthetic supply
Internal reservoir empty, Dosage failure
Electrical energy
Line supply fail, battery supply fail
Device’s control system
Watchdog alarm, Device inclined
Interface control
Occlusion or disconnection of Interface
MIRUS Reflector control
MIRUS Reflector expiration time
CAUTION The MIRUS Reflector control is only valid for a continuous connection
between MIRUS Interface plug and a powered MIRUS Controller (AC
connected). A disconnection of the plug or power off of the MIRUS
Controller will reset the timer.
Patient alarms
Control of
Control for
Anaesthetic concentration
Low and High et Sevo / et Iso / et Des
CO
2
concentration
Low and High et CO
2
Apnoea
Apnoea alarm