TIM MIRUS Controller - Preparation and Setup Procedures; Connecting to Mains Supply

3 Preparation
18 IFU, MIRUS Controller, en-GB, N.00
3 Preparation
3.1 Cleaning before first use
The MIRUS Controller does not come sterilised; the device has to be cleaned completely by
the user before it is used clinically for the first time.
Refer to chapter 6.2 Cleaning for more information.
3.2 Connecting to mains supply
Plug in power cable into the inlet on the
right side of the Controller.
Connect to AC supply.
100 to 230 V
AC
± 10%, 50 to 60 Hz ± 5%.
 Alarm lights turn on in green.
(lights pulsate= battery charges)
 Controller heats up.