TIM MIRUS Controller - Cleaning; Cleaning the Individual Components; General Advice

6 Maintenance and Cleaning
44 IFU, MIRUS Controller, en-GB, N.00
6.2 Cleaning
6.2.1 General advice
WARNING Observe the following safety precautions:
 Read the material data sheet for each cleaning agent.
 Wear gloves and safety glasses.
 Do not breathe the fumes.
CAUTION To prevent damage:
 Refer to the manufacturer’s data if you have questions about a
cleaning agent.
 Do not use organic, halogenated or petroleum based solvents,
anaesthetic agents, glass cleaner, acetone or harsh cleaning
agents.
 Do not use abrasive cleaning agents, such as steel wool, silver
polish or silver cleaner.
 Keep all liquids away from electrical parts.
 Do not permit liquids to go into the equipment’s housing.
 Do not autoclave any part of the MIRUS Controller.
 No part of the MIRUS Controller is sterilisable.
WARNING To prevent patient contamination:
 Follow general hygiene requirements of your hospital.
 Do not re-use single use components.
6.2.2 Cleaning the individual components
MIRUS Controller surface
a. Turn off the MIRUS Controller and ensure that the mains power cord is
disconnected.
b. Make sure the fill port is closed.
c. Remove MIRUS Reflector and interface plug.
d. Make sure the receptacle token is placed in the MIRUS Reflector receptacle and
the receptacle is sealed.
e. Make sure the three connector tokens are placed in the communication ports and
the ports are sealed.
f. Use a soft towel to clean the housing, the display and the user interface. When
using fluid cleaner, use a mild detergent and do not permit liquids to penetrate the
housing.