21
your computer desktop.
• PCSYNCREADYdisplayswhenthecomputerstartscommunicatingwiththewatch.Anerrormessage
displays if it was unsuccessful.
• PCSYNCINPROGRESSdisplaysduringthesyncprocess.
2. If a workout is in progress, the computer application requests confirmation that you wish to continue with
thesyncprocess.SelectNOtoendthesyncprocessandreturntoTimeofDaymode,orselectYESto
continue.
3. IfyouselecttheblinkingYESoptiontocontinuewiththecomputersync:
a. Another message pops up asking if you wish to save the workouts.
b.SelectYEStosavetheworkoutsession(Chrono/Timer/IntervalTimer)withsensorinformation.Thewatch
stopscurrentlyrunningworkouts,turnsofftheGPSandANT+
™
Radio, and continues the computer sync
process.
c.SelectNOtostoptheworkoutwithoutsaving.Thewatchcontinuesthecomputersyncprocess.
4. Whenthecomputerdownloadiscomplete,thePCSYNCTRANSFERCOMPLETEmessagedisplays,andthe
watchreturnstoTimeofDaymode.
NOTE:PressRADIO/BACKatanytimetocancelcomputerdownloadandgobacktoTimeofDayscreen.
ALARM MODE
The following features are offered in Alarm mode:
• Fiveindependentalarmswithselectablefrequency:daily,weekdays,weekends,once,andSundayto
Saturday
• Customizablealarmnames
• Five-minutebackupalarm
• INDIGLO
®
night-light flashes when alarm alert sounds
TURN AN ALARM ON OR OFF
YoucanturnalarmsonorofffromtheALARMscreen.
1. PressMODEuntilALARMdisplays.
2. Press UP to choose the alarm to turn on or off. The alarm name displays at the top.
3. PressDOWNtoturnthealarmonoroff.Whenthealarmison,itsfrequencydisplaysbelowthetime.
NOTE:Activealarmssoundattheirsettimes.Pressanybuttontosilenceanalarm.
CONFIGURE THE ALARM
1. PressMODEuntilALARMdisplays.
2. PressSET.
3. PressUPorDOWNtoselectthealarmtoset,andthenpressSELECT.
SET ALARM TIME
Withanalarmselected,setthealarmtimebyperformingthefollowingsteps:
1. PressUPtoselectTIME,andthenpressSELECT.
2. PressUPorDOWNtochangetheblinkingvalue,andthenpressNEXTtomovetothenextvalue.
3. PressDONE.
SET ALARM FREQUENCY
Withanalarmselected,setthealarmfrequencybyperformingthefollowingsteps:
1. PressUPorDOWNtoselectFREQUENCY,andthenpressSELECT.
2. PressUPorDOWNtoselectafrequency,andthenpressSELECT.
3. PressDONE.
RENAME THE ALARM
Withanalarmselected,renamethealarmbyperformingthefollowingsteps:
1. PressDOWNtoselectRENAME,andthenpressSELECT.
2. PressUPorDOWNtochangetheblinkingvalue,andthenpressNEXTtomovetothenextvalue.
3. PressDONE.