TINY AUDIO C10 User Guide
24
USING HANDS FREE FUNCTION
The TINY AUDIO C10 is capable of providing the Hands Free function for incoming and
outgoing phone calls from your mobile device using Bluetooth technology and listen to the
audio through your car radio. To use this function, you must enable Bluetooth, do the
Bluetooth pairing first. For detail, please refer to the menu setting sections for To Enable
Bluetooth, To Setup Bluetooth Paring. TINY AUDIO C10 can support up to two phone calls
at the same time to a Bluetooth connected phone while the system is operating in either
DAB mode or Audio Streaming mode.
To Receive Incoming Call
TINY AUDIO C10 provides the incoming call indication and allows you to operate on
the TINY AUDIO C10 to answer, reject, hang up, and switch between the two active
calls. The current audio from the DAB mode or the Audio Streaming mode is stopped
until the call is hung up.
1. Incoming call indication
While a call, either the first or the second call, is ringing, there will be a warning
tone from the car radio, and the screen will show the scrolling text of
《 device code: caller ID 》where device code is the code for corresponding
connected Bluetooth device, either A or B, and the caller ID is the phone number.
2. Answer an incoming call
Press
(LINK) key to answer the first or the second incoming call, the screen
will show《 LINE X 》 where X = 1 or 2 of the call sequence. When you answer
the second call, the first call is put on hold automatically.
3. Reject an incoming call
Press the
(BACK) key to reject the first or the second incoming call.
4. Switch between two active calls
Rotate the Rotary Knob [◄] [►] to switch between the two active calls.
5. Hang up a call
Press the
(BACK) key to hang up the active call.
Note:
While you are active on a call, you can press Rotary Knob to mute/un-mute
the active call with a warning tone from the car radio every 3 seconds when
the call is muted.
To Make Outgoing Call
You must make outgoing calls from your Smartphone and while the destination is