Tiny Audio C10 - Starting Up the System; Operating on TINY AUDIO C10; Operating on Car Radio

TINY AUDIO C10 User Guide
18
STARTING UP THE SYSTEM
1. Turn on your in-car audio system.
2. Enable the AF function on your car radio if it is equipped (Consult your car radio
manual or the car dealer if your car radio has AF feature, and how to enable AF
feature).
3. Tune the car radio’s FM frequency to FM 88.1MHz, which is the same as TINY
AUDIO C10 default FM TX frequency.
4. Start TINY AUDIO C10 by plugging the cigarette-lighter power plug into the cigarette
lighter, the audio system display will show 《 DABRADIO 》.
5. TINY AUDIO C10 will perform a Scan of DAB stations automatically.
6. If FM 88.1MHz is already used by a FM broadcaster or the station is noisy, change
the initial FM TX frequency as below:
Operating on TINY AUDIO C10
 Press and hold LINK for 3 seconds, TINY AUDIO C10 will set a new and
clear frequency to transmit the FM signal.
Operating on Car Radio
 Tune the car radio’s FM frequency to match to TINY AUDIO C10 FM TX
frequency shown on the LCD display screen; the TINY AUDIO C10 and the
car radio are now synchronized.
7. If your car radio does not have AF feature, do the following to change TINY AUDIO
C10’s LINKMODE to AutoScan instead of the default AFC.
7.1 Press Rotary Knob and then MENU to enter the menu function.
7.2 Rotate the Rotary Knob [◄] [►] until the screen shows《 LINKMODE 》.
7.3 Press Rotary Knob, and then rotate the Rotary Knob [◄] [►] until the screen
shows 《 AUTOSCAN 》.
7.4 Press Rotary Knob, the function of AutoScan is now enabled and the TINY
AUDIO C10 is operating in the AutoScan mode.
8. Now you can listen to the DAB stations. For the system operation, please refer to
USING DAB ADAPTER section.
9. While you are using AutoScan function and you are experiencing noise on the
listening DAB station, please refer to To Force Immediate FM Frequency Change or To
Set FM Transmitting Frequency Manually to manually switch to another FM
frequency.
10. To avoid unnecessary draining of the car battery when TINY AUDIO C10 is idle,
after 4 hours of idling from the user’s last action, TINY AUDIO C10 will be
automatically turned off. While in the standby mode, press Rotary Knob to return
TINY AUDIO C10 back to the operating mode.