Tiny Audio C10 - Page 20

TINY AUDIO C10 User Guide
17
2
SCAN
Press
 Recall memory preset in group 2.
Press and Hold
 Program memory preset in group 2 with the listening DAB station.
Function SCAN
 Perform a full scan for DAB stations.
3
MENU
Press
 Recall memory preset in group 3.
Press and Hold
 Program memory preset in group 3 with the listening DAB station.
Function MENU
 RADIOTXT – enable/disable display of DLS/DL+ information from the station
 DABORDER – DAB station list order sequence; order by alphabet or by ensemble.
 DABRESET – erase the DAB station list but keep the DAB memory presets and
then perform a full scan of DAB stations automatically.
 BT POWER – enable/disable Bluetooth function.
 BT PAIR – enter Bluetooth device pairing mode.
 BT INFO – display the connected device information.
 BT RESET – erase all existing paired devices setup.
 LINKMODE – select operating mode (AFC_H/AFC_L/AutoScan).
 ANTENNA – set ON for active DAB antenna, set OFF for passive antenna.
 FACTORY– return all system settings to defaults.
 UPGRADE – upgrade the module software to a new version.
 VERSION – display the current software version.
4
DAB
Press
 Recall memory preset in group 4.
Press and Hold
 Program memory preset in group 4 with the listening DAB station.
Function DAB
 Switch TINY AUDIO C10 audio input to DAB mode to listen to DAB programming.
LINK
Press
 Display adaptor’s current FM transmitting frequency.
 Select and set the FM transmitting frequency from a manual setting or from one of
the four memory presets.
 Save the FM transmitting frequency setting to one of the four memory presets.
 Answer the incoming phone call.
Press and Hold
 Perform an immediate FM transmitting frequency change.
BACK
Press
 Recall the last listened DAB station.
 Cancel an operation, or return to home screen display from the menu selection.
 Reject the incoming phone call or hang up the active call.
Press and Hold
 Reset FM transmitting frequency to the frequency saved in FM preset 1. Within 30
seconds, press and hold again to return the frequency to 88.1MHz.