TINY AUDIO C10 User Guide
34
them, refer to the procedure outlined in the TROUBLESHOOTING section for
detail.
ATTENTION
The TINY AUDIO C10 comes equipped with the AFC function. In order to use this
function, your car radio must have AF (alternative frequency) feature, and AF must
be enabled. Please consult your car radio manual or the car dealer for these
requirements before using this function.
While working with the AFC function, the possible factors that could affect its
normal operation are:
1.
The FM sensitivity varies among car radios and the sensitivity can affect AFC’s
performance.
2. The algorithm implemented in each car radio’s AF feature varies and this can
affect radio’s FM frequency tuning when triggered by AFC.
3. While the system is in Aux mode and listening to an audio device, if the device’s
volume is turned up too high, it can affect AFC’s performance.
If AFC function is unable to function normally, please disable AFC and use
AutoScan mode instead. Refer to the next section To enable AutoScan.
To Enable AutoScan
If your car radio does not have AF feature, then you must disable AFC and enable
AutoScan instead.
1. In the menu function, rotate Rotary Knob [◄] [►] until the screen shows
《 LINKMODE 》.
2. Press Rotary Knob, and then rotate Rotary Knob [◄] [►] until screen shows
《 AUTOSCAN 》.
3. Press Rotary Knob, the function of AutoScan is now enabled. The TINY AUDIO
C10 is operating in the AutoScan mode,
Note:
Switching to the AutoScan mode does not change the current FM transmitting
frequency as it remains the same as before the switch.
Switching to the AutoScan mode, it disables the AFC function.
TINY AUDIO C10 will keep searching automatically for unused FM frequency.
To Next Page
Loading...
