Tiny Audio C10 - Troubleshooting

TINY AUDIO C10 User Guide
38
TROUBLESHOOTING
Please read this user manual carefully before using the TINY AUDIO C10 In-Car DAB
Adapter. If you still have difficulties to use this unit, this section gives some of the most
likely solutions to the problems you might have.
 I cannot find any DAB stations.
Ensure that DAB coverage exists in your area. Please visit www.worlddab.org or
www.digitalradionow.com to check for DAB coverage.
 I forget the FM transmitting frequency setting of TINY AUDIO C10.
Press LINK key the screen will show the current FM Transmitting frequency.
 I cannot hear DAB program when I start up my car and turn on the car radio.
Check the following:
1. Follow the instruction on the section STARTING UP THE SYSTEM to initialize the
FM transmitting frequency on TINY AUDIO C10 and the car radio.
2. Make sure that the car radio is not in mute and check the volume settings of the
car radio.
3. Make sure TINY AUDIO C10 is not in the Audio Streaming mode, if so, press
Rotary Knob then DAB to return to DAB mode.
 While listening to a DAB station, I lost reception suddenly and hear static noise
or a FM program
1. Check if TINY AUDIO C10 station information shows 《 POOR SIG 》 or
《 UNAVAIL 》, if so, you may be leaving the signal coverage area, please refer to
To Listen to the DAB stations to select another station. Also, the station may be
unavailable temporarily as you drive into a tunnel.
2. If TINY AUDIO C10 is in AFC mode, the FM Transmitting Frequency for TINY
AUDIO C10 and the car radio listening Frequency maybe out of sync. To reset
them, do the following:
a) Reset to 88.1MHz
Operating on Car Radio
 Press FM preset of your car radio to the frequency 88.1MHz if you have
previously saved for DAB reception. Otherwise, tune the car radio to FM
frequency 88.1MHz manually.
Operating on TINY AUDIO C10