Tiny Audio C10 - Troubleshooting

TINY AUDIO C10 User Guide
35
Then, when necessary, you can press and hold the LINK control key to force
the immediate FM transmitting frequency change to use this searched
frequency as the new transmitting frequency. You must also tune your car
radio to this new FM frequency to receive DAB services.
To Enable RC Beep Tone
When you enable RC beep tone, TINY AUDIO C10 will respond with a beep tone, each
time an operation is performed on the remote control.
1. In the menu function, rotate Rotary Knob [◄] [►] until the screen shows
《 RC BEEP 》.
2. Press Rotary Knob to enter RC beep tone selection operation.
3. Then you can rotate Rotary Knob [◄] [►] until the screen shows《 BEEP ON 》
to enable the RC beep tone.
4. Or you can rotate Rotary Knob [◄] [►] until the screen shows 《 BEEP OFF 》
to disable the RC beep tone.
5. Finally, press Rotary Knob to set the RC beep tone, screen will then show
《 DONE 》.
Note:
The default setting is OFF.
To Set Antenna Power
For TINY AUDIO C10 to work with the active antenna, the antenna power must be set
to ON. TINY AUDIO C10 can also work with a passive antenna, you must set the
antenna power to OFF.
1. In the menu function, rotate Rotary Knob [◄] [►] until the selection is
《 ANTENNA 》.
2. Press Rotary Knob to enter Antenna Power selection operation.
3. Then you can rotate Rotary Knob [◄] [►] until the screen shows 《 ANT ON 》
to set the Antenna Power On.
4. Or you can rotate Rotary Knob [◄] [►] until the screen shows《 ANT OFF 》to
set the Antenna Power Off.
5. Finally, press Rotary Knob to set the Antenna Power.
Note:
The default Antenna Power setting is ON.