105
20.1. General Description
The supplied CD-ROM contains the A-9000 series maintenance software, which executes the following utility
programs.
20. HOW TO USE THE SUPPLIED SOFTWARE
Updating firmware
Parameter file
Others*
Updates the firmware.
9000 to PC Stores parameters set at the unit to your PC.
PC to 9000 Transfers parameters stored in your PC to the unit.
Status Monitor Monitors the unit's operation status.
Virtual control I/O Activates the control input.
* Used to check the unit at installation.
[System requirements]
Ensure your PC operates on Windows XP and also meets the following requirements, or this software will not
run properly.
Serial port: RS-232C port or compatible with USB-to-RS232C converter
Media & Drive: CD-ROM
Note: Windows is a trademark of Microsoft Corporation.
To Next Page
Loading...
