Toa A-9060DH - Adjustment Mode Settings

86
LASTEvent Activation at Power-On
[When the function selection is set to EVENT]
[When the function selection is set to REMOTE]
[When the function selection is set to ANC]
OFF
CIN01
OFF
COUT01 (When the interlock output control is ON)
ANC Monitor Switching ON/OFF
Control Input Terminal
Interlock Output Control
Interlock Output Terminal
LASTInput Channel Activation at
Power-On
[When the function selection is set to CHANNEL]
Default
IN1
ON
0.0 dB
14.1.5. Adjustment mode settings
[Settings when the D-001T is used]
Setting Item
Input Channel Selection
Channel Control
Channel Gain
0 dB
OFF
OFF
01 (When EQ = ON and EQ band number = 01)
0 dB (When EQ = ON and EQ band number = 01)
1.5 (When EQ = ON and EQ band number = 01)
31.5 Hz (When EQ = ON and EQ band number = 01)
OFF
OFF
OFF
–30 dB
BASS/TREBLE
Loudness Compensation
EQ
EQ Band Number
Gain
Q
Center Frequency
HPF
LPF
Compressor
VOX Sensitivity
Input Channel Settings
–6
0
20
3:3
0 dB
Lowest Output Level
Highest Output Level
Sampling Time
Gain Ratio
Reference Level
[Settings when the AN-001T is used]
OFF
REMOTE1 terminal for OUTPUT1 control, REMOTE2 terminal for
OUTPUT2 control
ALL
Remote Controller Type
Remote-Controlled Channel
Volume-Controlled Signal