74
10.8.2. Control output function setting items
Unless otherwise specified, use the Parameter setting knob for each parameter selection.
(F1) Control output function setting
C-
O
UT01 N
ON
E
Select the function assigned to the control output terminal.
[When the function is set to POWER]
[When the function is set to SCENE]
C-
O
UT01 P
O
W
ER
(F2)
(When the control output function is set to POWER)
Provides a Level output when the power is turned on.
Assigning a function to this terminal overwrites the previously set function on it if there is.
(F3)
(When the control output function is set to SCENE)
C-
O
UT01 SCENE
Provides a Level output when a Scene memory is recalled.
Assigning a function to this terminal overwrites the previously set function on it if there is.
(F4) Scene memory bank number selection
C-
O
UT01– SCENE 01
Select the Scene memory bank number that causes the selected control output terminal to provide a Level
output when the Scene memory is recalled.
Assigning a function to this terminal overwrites the previously set function on it if there is.
NONE (default), POWER (Power ON/OFF remote control), SCENE (Scene memory
recall), CH ON (channel ON)
Setting Range
[When the function is set to CH ON]
C-
O
UT01 CH
O
N
(F5)
(When the control output function is set to CH ON)
Provides a Level output when the input or output channel becomes on.
Assigning a function to this terminal overwrites the previously set function on it if there is.
To Next Page
Loading...
