89
12.1. Default Setting Table
12.1.1. Input settings
Default
IN1
ON
0.0 dB
(IN1 – 8)
Setting Item
Input channel Selection
Channel Control
Channel Gain
Channel Name
[Settings when the D-001T is used]
OFF
–10 dB
OFF
0 dB
OFF
OFF
01 (When EQ = ON and EQ band number = 01)
0 dB (When EQ = ON and EQ band number = 01)
1.5 (When EQ = ON and EQ band number = 01)
31.5 Hz (When EQ = ON and EQ band number = 01)
OFF
OFF
OFF
OFF
–30 dB (When the gate function is ON)
Phantom Power
Input Sensitivity
NOM Attenuation Function
BASS/TREBLE
Loudness Compensation
EQ
EQ Band Number
Gain
Q
Center Frequency
HPF
LPF
Compressor
Gate ON/OFF
Gate Threshold Level
[Settings when the ZP-001T is used]
OFF
PAGING PORT
Pre-paging Tone
Operation Mode
[Settings when the AN-001T is not used]
OFF
D-001T: PRIORITY 1 (When the ducker function is ON)
Modules except the D-001T: PRIORITY 2 (When the ducker function is ON)
OFF (When the ducker function is ON)
0 dB (for all the assigned output channels)
Ducker ON/OFF
Ducker Priority Level
Ducker Attenuation Level
Assigned Output Level
[Settings when the AN-001T is used]
BYPASS
–10 dB
OFF
OUT1
OFF
OUT1 (When the monitor ON/OFF setting is ON)
–6 dB
0 dB
20 sec
3:3
0 dB
ANC Operation ON/OFF
Input Sensitivity
Phantom Power
ANC-Activated Output
Monitor ON/OFF
Monitor Output Channel
Lowest Output Level
Highest Output Level
Sampling Time
Gain Ratio
Reference Level
To Next Page
Loading...
