Toa M-9000 - Password setting

80
10.9.4. Password setting
When using a password, set the password before performing lock setting for each key.
Step 1. Press the Utility key.
The Utility setting screen is displayed.
Step 2. Press the Down shift key until the keylock screen is displayed.
Note
No password is factory-preset.
(The [ _ _ _ _ ] indication is displayed.)
Step 3. Press the Right shift key, and then Down shift key.
The password entry screen is displayed.
Step 4. Enter a password using the Input channel selection keys (1 – 8).
The position on the extreme left flashes first for character entry.
Entering a character changes the [_] indication into [ ].
Use up to 4 characters to set the password.
Step 5. Press the Up shift key after setting completion.
The display returns to the key lock status screen.
Step 6. Perform key lock setting.
Advance to Step 4 on the next page.
STERE O LINK
UTILITY
–––
KEYL
O CK UNL O CKED
SETPASS
W O RD _ _ _ _
KEYL
O C K
INPUT SELECT
2
SETPASS W O RD _ _ _
SETPASS
W O RD _ _ _
SETPASS
W O R D
Password setting screen
Keylock
1
2
5
4
3