TOHATSU MX 50D2 - Daily Inspection and Checks

1-18
Service Information
2st 50D2 2011
GB
a
a 5-25 mm (0.2 - 1.0 in)
5)
Installation of Outboard Motor (Rigging)
Check that outboard motor is fixed on the hull with
installation bolts and nuts securely. Check location of anti-
ventilation plate relative to boat bottom.
4) Fuel and Fuel Line
Check that fuel tank contains sufficient amount of pre-
mixed gasoline, fuel line is connected and does not leak.
CAUTION
Supply only unleaded regular octane gasoline
into fuel tank. Use fuel mixed with oil.
Fuel and oil mixing ratio is 50:1. For breaking
period, 25:1 mixture shall be used.
Test-run to determine the best installation height.
Anti-ventilation plate standard position a :
5 - 25 mm (0.2 - 1.0in) below boat bottom
MX50D2ECH01120411.qxd12.4.183:49PM ページ18