Note: when assembling, align the unfi lled corner of the oil pump shaft with the corner of the inner rotator, and
• Once the oil pump plate is aligned with the dowel pin -- mount it.
• Tighten the oil pump plate screw.
• After assembling, gently turn the oil pump shaft to ensure that the oil pump turns smoothly.
• Install the oil pump on the crankcase.
Note: before installing, fi ll the oil pump with oil. When installing, the arrow of the oil pump body must be up-
• Tighten the oil pump positioning bolts to 95 in. / lbs.
• Align the oil pump driving gear with the oil pump shaft.
• Install the driving gear and chain.
• Install the driving gear positioning nut and tighten it to 95 in. / lbs.
• Install the partition board and tighten bolts to 87 in. / lbs.
• Install the starting reduction gear and starting clutch (left-handed threads).
• Install the gasket and dowel pins.
• Install the right crankcase cover bolt.
• Install the trigger winding and the stator coil.
• Tighten the right crankcase cover bolts to 95 in. / lbs.
Note: the bolt should be gradually, diagonally tightened in two to three times. After fi nishing the installation,
inspect for any oil leaks in all components.
To Next Page
Loading...