Tomberlin CrossFire 150 - CVT Mechanism Overview

REAR TRANSMISSION MECHANISM INSPECTION AND SERVICING
The structure of the rear transmission mechanism is shown in the picture on the previous page.
1. Cover Transmission
2. Gasket Transmission Cover
3. Radial Ball Bearing
4. Radial Ball Bearing
5. Radial Ball Bearing
6. Fill and Drain Plug
7. Sealing Washer
8. Oil Seal
9. Final Gear
10. External Circlip
11. Output Shaft
12. Counter Shaft
13. Nut
14. Washer
15. Input Shaft
TRANSMISSION CASE OIL INSPECTION
Note: Use a level surface when inspecting the oil level of the transmission case.
• Inspect if there is oil leaking around the transmission case.
• After the engine stops, remove the transmission case oil viewing bolt.
• Observe the oil level when the oil level is parallel with the observing hole.
• When the oil level is too low, use the appropriate oil and add until oil fl ows from the level screw.
• Mount the transmission case oil viewing bolt and washer.
• Assure that the bolt oil seal is undamaged.
TRANSMISSION CASE OIL REPLACEMENT
Inspect fi nal gear oil level monthly and change fi nal gear oil every 3 months.
Level screw Drain plug
33