The belt driven CVT mechanism consists of a notched driven belt and two belt pulleys (the drive belt pulley and
the driven belt pulley) whose diameter can be adjusted. The driving belt pulley is mounted on the engine crank-
shaft, and the driven belt pulley connects with the rear driven mechanism.
• Turn adjustments nut clockwise to remove defl ection.
• Leave 3/8 – 3/4 in. defl ection in chain.
• Lubricate chain after every use while chain is still warm
• Only use O-Ring safe chain lubrication for the chain on this go-kart
• Raise and secure rear end of the machine.
• Remove cotter pins on rear axle nuts.
• Remove rear wheel and hub assembly by sliding off splines of axle.
• Loosen nuts on bearing carrier and remove bolts.
To Next Page
Loading...