TRANSMISSION BELT INSPECTION
• Remove the left crankcase cover.
• Inspect if the transmission belt is worn.
• Measure the width of the belt.
• Replace the belt if its width is less than the service limit below:
Service limit 19.0 mm 0.748 in.
• Refer to the drive pulley removal and installation procedure for replacement. Only use a brand identical belt
• Turn fuel to OFF position
• Remove throttle cable, choke wire, fuel line, and vacuum line.
• Loosen clamps on intake manifold and air fi lter.
CARBURETOR DISASSEMBLY AND INSPECTION
• Remove the four screws on fl oat bowl and remove fl oat bowl.
• Check fl oat bowl for dirt and fuel residue.
• Remove fl oat, fl oat needle valve, main jet, needle jet holder, needle jet, and pilot jet.
• Clean and inspect fl oat and fl oat needle valve for wear.
• Clean and inspect main jet, needle jet holder, needle jet, and pilot jet.
To Next Page
Loading...