• Remove the clutch shoes and the spring.
• Mount the clutch damper rubber on the drive plate pin.
• Mount the new clutch shoes set and spring on the drive plate.
• Install the connecting piece, the circlip, and the bottom plate.
• Reverse the removal procedure to install.
DRIVEN BELT PULLEY REMOVAL
After removing the clutch friction plate, remove the guide pin, the roller, and the movable driven plate.
• Remove the oil seal on the movable driven plate.
DRIVEN BELT PULLEY INSPECTION
• Measure the free length of the driven belt pulley spring.
Service limit 163.7 mm 6.420 in.
• Inspect if there is any abrasion or damage on the driven plate.
• Measure the outer diameter of the driven plate pulley hub.
Service limit 33.94 mm 1.3365 in.
• Inspect if there is any abrasion or damage of the movable driven plate.
• Measure the inner diameter of the movable driven plate.
Service limit 34.06 mm 1.341 in.
• Inspect if the groove of the guide pin for wear.
To Next Page
Loading...