• Remove stator plate assembly.
• Remove the right crankcase cover.
• Remove the left crankcase cover.
• Remove the starting clutch nut.
Note: The nut is a left-handed thread.
• Remove the starting clutch set.
STARTING CLUTCH INSPECTION
• Inspect if the movement between the clutch and the driving gear is normal.
- When turning clockwise, the driving gear should turn smoothly.
- The driving gear should lock when turned counterclockwise.
• Inspect if there is any abrasion or damage on the surface between the driving gear and the needle bearing. It
should be replaced when the surface is unusual.
• Measure the inner diameter of the driving gear. It should be replaced when the diameter is more than the ser-
Service limit 32.06 mm 1.2625 in.
• Inspect the condition of the needle bearing. If damage is extensive it should be replaced.
• Inspect if there is any damage to the surface between the outer clutch component and the roller.
• Inspect for damage to the roller.
• Inspect for damage to the spring.
To Next Page
Loading...