The clutch shown in the picture below is the automatic dry centrifugal weight clutch.
DRIVE BELT PULLEY REMOVAL
• Remove the left crankcase airpipe lock bolt.
• Remove the kick starter and remove the left crankcase fi xing bolt.
• Remove the left crankcase cover.
• Remove the gasket and the dowel pin.
• Remove the drive plate.
• Remove the driven belt from the drive plate.
• Remove the movable drive plate set.
• Remove the centrifugal rollers.
DRIVE BELT PULLEY INSPECTION
• Inspect if there is any damage to the centrifugal roller.
• Measure the outer diameter of the centrifugal roller.
Service limit 17.0 mm 0.6695 in.
• Measure the inner diameter of the movable drive plate.
Service limit 24.06 mm 0.947 in.
• Inspect if there is any damage to the drive plate hub.
• Measure the outer diameter of the drive plate hub movable surface.
DRIVE BELT PULLEY INSTALLATION
Apply some grease evenly in the movable drive plate. Put the centrifugal rollers into the movable drive plate.
• Install the ramp plate.
To Next Page
Loading...