BRAKE BLEEDING FLUID CHANGE
This procedure should be used to change the fl uid or bleed the brakes.
• Remove reservoir cap and diaphragm. Clean and inspect.
• Drain old fl uid from reservoir. Add brake fl uid to upper mark on reservoir.
• Slowly pump break pedal until pressure builds and holds.
• While maintaining pedal pressure, open bleeder valve. To bleed air off, close valve.
• Repeat procedure until all air has been purged from system and clean fl uid appears.
Note: Maintain fl uid in reservoir while performing procedure
• Remove four bolts holding disc to axle
• Visually inspect disc for wear or damage. If measurements fall beyond service limit, replace disc.
Service Limit: 3 mm 0.120 in.
• Install new disc and reattach four bolts using Loctite 242.
• Torque to 18 ft. / lbs.
To Next Page
Loading...