IGNITION COIL INSTALLATION
•Reverse the removal procedure for installation.
Note: When installing, connect the blue wire from the CDI to the green terminal of the ignition coil, and con-
nect the black wire to the second terminal.
PRIMARY IGNITION COIL INSPECTION
Standard Value 0.1 ~ 1.0 Ω (20º C)
If the resistance value is -, it indicates the coil is broken and should be replaced.
SECONDARY IGNITION COIL INSPECTION
Install the spark plug cap, and measure the resistance value of the secondary ignition coil.
Standard Value 7 ~ 9Ω (20º C)
The resistance value is in the standard range indicates it is good; however, - indicates the coil is broken.
Remove the spark plug cap, and measure the resistance value of the secondary ignition coil.
Standard Value 2 ~ 4Ω (20º C)
• Clean up the carbon around the spark plug to prevent it from dropping into the cylinder when removing the
Note: When installing, connect the black/yellow wire of the primary ignition coil with the black/yellow connec-
tor of CDI, and the green wire with the green connector of CDI.
• Clean up the fi lth and carbon accumulation on the spark plug with a steel brush or a blade.
• Inspect the spark plug gap, in general it should be about:
0.6 ~ 0.7mm 0.024 ~ 0.028 in.
• When the carbon accumulation and wear of the spark plug are too serious, replace the spark plug. Replace
with the spark plug of the same specifi cation.
To Next Page
Loading...