TomTom Bandit Reference Guide

18
Tip: You can also install your TomTom Bandit upside down. Set the ROTATION image setting to
180 to turn the image 180 degrees.
1. Before you install a mount, find the best position for your TomTom Bandit.
Only attach the mount to a smooth, hard surface. The mount won't securely attach to porous,
textured or soft surfaces.
To install the TomTom Bandit at different angles and on the left or right side of a helmet, you
can turn the TomTom Bandit's base more than 180 degrees around the TomTom Bandit body.
Tip: Use the Mobile app live viewfinder to set the TomTom Bandit to the correct view.
2. Clean the area where you want to install the mount.
Wax, oil, dirt and moisture reduce adhesion, which can result in a weak bond. Make sure that
the area is completely dry.
3. In dry, room-temperature conditions, attach the mount base. Push the mount base firmly down
onto the surface.
The mount base won't attach securely if you install it in damp and cold conditions.
4. Wait 24 hours for the adhesive to cure.

TomTom Bandit Specifications

General

Photo Resolution	16 MP
Sensor	CMOS
Battery	1900 mAh
Battery Life	Up to 3 hours
GPS	Yes
Resolution	4K
Image Sensor Size	1/2.3-inch
Field of View	160°
Storage	MicroSD card (up to 128GB)
Connectivity	Wi-Fi, Bluetooth
Sensors	Accelerometer, Gyroscope
Dimensions	94 x 38 x 52 mm
Weight	190 grams
Frame Rate	30fps (4K), 60fps (1080p), 120fps (720p)
Waterproof	IPX7 (without additional housing), IP68 with optional lens cover