Chapter 3 – Athene Setup
19
target rate is entered on the main screen. The floor (belt) speed
is automatically adjusted to maintain the correct rate based on
the forward speed and working width.
The floor speed is manually controlled using and
. This mode is commonly used to run the floor belt while
the spreader is stationary (for example; to empty remaining
contents).
Set the target application rate. Vary application
rate (± % increments).
Boundary reduction. The left-hand spinner RPM can be
slowed down to reduce the spread width when traversing the
field boundary (see Setting up boundary reduction, page 35).
To Next Page
Loading...
