Chapter 3 – Athene Setup
25
l Average weight: Sets whether the average weight is visible on the
INFO screen.
l Info weight: Selects whether the INFO page is based on theorical
weight (rotations of floor) or the weight reduction from the load
cells.
Loadcell correction:
l Correction span: Amount the calibration factor can change by after
each dynamic calibration.
l Min static weight: Weight of product that must be spread during a
static test.
l Dynamic time: How often a dynamic calibration is made.
l Dynamic weight: Weight of product that must be spread during
each dynamic calibration.
l Start delay: Delay at the start of each new load before dynamic
corrections are made.
l Steady weight: % change that is allowed each second before weight
reading is considered unstable.
l Headland delay: Delay when the machine is switched in to work
before dynamic corrections are made.
l Cal factor delay: Pause time between the previous dynamic
correction being made and the new correction starting.
l Dynamic fill weight: When the hopper weight increases by this
value it is considered re-filled.
l Correction span fast: Amount the calibration factor can change by
if weight is below 'Fast empty point'.
Overload log: A list showing each time the weight in the spreader went
over the maximum permissible load.
Diagnostics menu
The Diagnostics menu provides a method to view the following:
l Channels: Shows the current forward speed, target floor speed and
current floor speed.
To Next Page
Loading...
