Toro Groundsmaster 3505-D - Page 52

g031641
Figure63
1.Hydraulic-tankcap
3.Removethehydraulic-tankcap(Figure63).
4.Removethedipstickfromthellerneckand
wipeitwithacleanrag.
5.Insertthedipstickintothellerneck,then
removeitandchecktheuidlevel.
Note:Theuidlevelshouldbewithin6mm
(1/4inch)ofthemarkonthedipstick.
6.Ifthelevelislow,addtheappropriateuidto
raisetheleveltotheFULLmark.
7.Installthedipstickandcapontothellerneck.
ChangingtheHydraulicFluid
ServiceInterval:Every2,000hours—Ifyou
areusingtherecommended
hydraulicuid,changethe
hydraulicuid.
Every800hours—Ifyouarenotusingthe
recommendedhydraulicuidorhaveever
lledthereservoirwithanalternativeuid,
changethehydraulicuid.
HydraulicFluidCapacity:13.2L(3.5USgallons)
Iftheuidbecomescontaminated,contactyourlocal
Torodistributortoushthesystem.Contaminated
uidlooksmilkyorblack.
1.Turntheengineoffandraisethehood.
2.Disconnectthehydrauliclineorremovethe
hydrauliclterandletthehydraulicuidowinto
adrainpan(Figure66andFigure64).
g031643
Figure64
1.Hydraulicline
3.Installthehydrauliclinewhenthehydraulicuid
stopsdraining(Figure64).
4.Fillthereservoir(Figure65)withapproximately
13.2L(3.5USgallons)ofhydraulicuid;refer
toHydraulicFluidSpecications(page51)and
CheckingtheHydraulicFluidLevel(page51).
Important:Useonlythehydraulicuids
specied.Otheruidscoulddamagethe
system.
g031641
Figure65
1.Hydraulic-tankcap
5.Installthereservoircap.
6.Starttheengine.
7.Useallthehydrauliccontrolstodistributethe
hydraulicuidthroughoutthesystem,checkfor
leaks,thenshutofftheengine.
8.Checktheuidlevelandaddenoughtoraise
theleveltotheFULLmarkonthedipstick.
Note:Donotoverll.
52