Slope Safety (continued)
• Follow procedures and rules for operating on slopes. These procedures must include
surveying the site to determine which slopes are safe for machine operation. Always use
common sense and good judgment when performing this survey.
• Avoid starting or stopping on a slope. If the machine loses traction, proceed slowly,
straight down the slope.
• Avoid turning on slopes. If you must turn, turn slowly and keep the heavy end of the
machine uphill.
• Keep all movements on slopes slow and gradual. Do not make sudden changes in speed
or direction.
• If you feel uneasy operating the machine on a slope, do not do it.
• Watch for holes, ruts, or bumps, as uneven terrain could overturn the machine. Tall grass
can hide obstacles.
• Use caution when operating on wet surfaces. Reduced traction could cause sliding.
• Evaluate the area to ensure that the ground is stable enough to support the machine.
• Use caution when operating the machine near the following:
– Drop-offs
– Ditches
– Embankments
– Bodies of water
• The machine could suddenly roll over if a tire goes over the edge or the edge caves in.
Maintain a safe distance between the machine and any hazard.
• Do not remove or add attachments on a slope.
• Do not park the machine on a slope.
Adjusting the Roll Bar
WARNING
A rollover can cause injury or death.
• Keep the roll bar in the raised locked position.
• Use the seat belt.
Operation: During Operation Page 5–8 3455-524 A
To Next Page
Loading...
