Checking the Engine Coolant Level (continued)
G428621
1. Remove the radiator and expansion tank
caps.
2. Check the coolant level in the radiator.
Note: Fill the radiator to the top of the filler
neck and the expansion tank to the full mark.
3. If the coolant is low, add the mixture to the full
mark.
4. Install the radiator cap and expansion tank
cap.
Changing the Engine Coolant
G416157
1. Remove the radiator and expansion tank
caps and drain plug .
2. After the fluid has drained, install the drain
plug.
3. Add the coolant mixture at the cap to keep the
level at the top of the filler neck and the
expansion tank.
Note: Fill the radiator to the top of the filler
neck and the expansion tank to the full mark.
4. Install the cap.
Checking the Radiator Hoses
Check the radiator hoses for leaks, abnormal swelling, or other signs of deterioration. Check
for leaks or corrosion at the water pump and fittings.
Belt Maintenance
Checking the Drive Belt Tension
The belt is properly tensioned when it moves about 7–10 mm (1/4–3/8 inch) when you push
it at the long span.
3455-524A Page 7–14 Maintenance: Cooling System Maintenance
To Next Page
Loading...
