Checking the Plow Blade
Check the plow blade for wear. Replace it as needed.
Changing the Plow Blade
IMPORTANT
The plow blades are heavy; use 2 people to complete this procedure.
G418318
1. Shut off the engine.
Note: Ensure that the vibratory plow is raised
high enough for the blade to be changed.
2. Flip the 2 circular snap rings
over and
remove the snap-ring pin.
3. Pull the 2 pins
out of the blade.
4. Place the new blade into the plow blade
assembly and secure it with 2 pins and 2 snap-
ring pins.
Changing the Plow Skid Shoes
1. Raise the plow about 91 cm (36 inches) off the ground.
2. Shut off the engine and remove the key.
G418319
3. Remove the bolts securing the skid shoes to
the plow.
4. Install the new skid shoes and secure them
with the previously removed hardware.
Maintenance: Plow Maintenance Page 7–21 3455-524 A
To Next Page
Loading...
