Starting and Shutting Off the Engine (continued)
Shutting Off the Machine
1. Move the machine to a level surface.
2. Engage the parking brake.
3. Lower any attachments to the ground.
4. Set all controls to N
EUTRAL.
5. Move the throttle lever to S
LOW.
6. Turn the ignition key to O
FF.
Note: If the engine has been working hard or is hot, let it idle for 5 minutes before
turning the ignition key off. This helps cool the engine before it is stopped. In an
emergency, you can shut off the engine immediately.
Note: If you are leaving machine unattended, remove the key.
7. For maintenance or long-term storage, disconnect the battery using the battery
disconnect switch.
IMPORTANT
Wait 2 minutes after shutting off the engine before disconnecting the battery.
Plow
Positioning the Machine
1. Start the engine.
2. Drive the machine to the starting point, in line with the planned path.
3. Engage the parking brake.
4. Remove the plow rotation pin and place it in the storage location.
5. Lower the plow blade to the starting point of the trench.
6. Shut off the machine.
Operation: During Operation Page 5–10 3455-524 A
To Next Page
Loading...
