Changing the Gearbox Oil
G418828
1. While the oil is warm, remove the plug and
drain the tank.
2. Install the plug.
3. Replace the filter each time the oil is changed.
4. Add fluid at the fill point
until the oil level is
even with the bottom of the fill plug.
Cooling System Maintenance
Cooling System Safety
• Swallowing engine coolant can cause poisoning; keep out of reach from children and
pets.
• Discharge of hot, pressurized coolant or touching a hot radiator and surrounding parts
can cause severe burns. If you must work on or near the radiator, allow it to cool or wear
gloves.
• Always allow the engine to cool at least 15 minutes before removing the radiator cap.
• Use a rag when opening the radiator cap, and open the cap slowly to allow steam to
escape.
Coolant Specifications
Note: Specifications and design are subject to change without notice.
Coolant Specification a mixture of 50% ethylene glycol and 50% water
Engine and Radiator Coolant Capacity 10.2 L (10.8 qt)
Checking the Engine Coolant Level
Note: Do not use only water or alcohol/methanol based coolants. Use a mixture.
Maintenance: Drive System Maintenance Page 7–13 3455-524 A
To Next Page
Loading...
