Controls Maintenance
Adjusting the Parking Brake
1. Shut off the engine.
G378801S
2. Disengage the parking brake.
3. Rotate the knob
to adjust the parking brake.
• Counterclockwise—loosen
• Clockwise—tighten
Note: Rotate the knob no more than 1
revolution each time.
4. Test the parking brake.
5. Repeat steps above until the machine does not
move forward when the parking brake is
engaged.
Adjusting the Neutral Position
If the machine moves in any direction when you release the traction control lever, adjust the
traction drive neutral position.
1. Lower all attachments, engage the parking brake, shut off the machine, and block the
tires.
2. Loosen the jam nuts on each end of the traction rod.
G416197
3. Adjust the adjustment nut depending on
which way the machine is moving:
• If the machine is moving forward, turn the
nut counter clockwise.
• If the machine is moving rearward, turn the
nut clockwise.
4. Tighten the jam nuts on each end of the rod.
5. Test the machine to see if further adjustment is
needed.
3455-524A Page 7–16 Maintenance: Controls Maintenance
To Next Page
Loading...
