Toro Micro-Master Series - Connecting Valve Wire

Micro-Master Touch User Guide
10
© 2014 Toro Australia Pty Ltd Ver 1.2, June 2014
For Remote Unit number 4, the number 4 switch should be ON, all others OFF.
There can only be one Master controller and one of each of the remotes connected as a group.
In the example below, a unit has been configured as Remote Unit number 1.
Figure 6 - Master / Remote Selection Switch
4.4
Connecting Valve Wire
1. Remove bottom cover.
2. Route 1 wire from each valve though one of the three holes in the bottom of the
controller case. Insert each lead into the appropriate terminal on the connector.
For ease of wiring the connector heads can be removed if required.
3. The common wire for each valve should be attached to a single “Common” wire.
Connect this Common wire to one of the terminals labeled COMMON.
4. When all valve wires have been connected, ensure that all holes and spaces
between valve wires are sealed with a silicone sealant or similar. This ensures
that insects, ants and vermin cannot enter the controller.