Toro Multi Pro 5800-G - Removing the Agitation-Manifold Valve

g032545
Figure109
Section-ValveActuatorShown(theagitationvalveactuator
issimilar)
1.Actuator(sectionvalve)3.Stemport
2.Retainer
3.Removetheactuatorfromthemanifoldvalve.
RemovingtheAgitation-Manifold
Valve
1.Removethequickconnectpinthatsecuresthe
quick-connectcouplerfortheagitationhoseto
themanifoldfortheagitationvalve(Figure110).
g191301
Figure110
1.Flange(pressure-lter
head)
4.Quick-connectpin
2.Flange(couplingadapter)5.Quick-connectcoupler
(agitationhose)
3.Flangeclamp
6.Quick-connecttting
(agitation-valvemanifold)
2.Removethe3angeclampsthatsecurethe
agitation-valvemanifoldtotheangesofthe
pressure-lterheadandthecouplingadapter
(Figure110).
3.Removethe2ange-headbolts(1/4x3/4inch)
and2angelocknuts(1/4inch)thatsecurethe
agitation-valvemanifoldtothevalvesupport
(Figure111).
g191302
Figure111
1.Manifold(agitationvalve)4.Flange-headbolt(1/4x
3/4inch)
2.Valvesupport
5.Gasket
3.Flangelocknut(1/4inch)
4.Removetheagitation-valvemanifoldand
gasketsfromthemachine(Figure111).
Note:Ifneeded,loosenthemountinghardware
forthepressure-lterheadasneededtoprovide
clearance.
Note:Retaintheangeclamps,gaskets,and
quick-connectpinsforinstallationinInstalling
theAgitation-ManifoldValve(page85).
80