Toro Reelmaster 5210 - Lift Control Manifold Service

Reelmaster 5010 SeriesHydraulic System (Rev. C) Page 4 -- 90
Lift Control Manifold Service
1. Lift control manifold
2. Check valve (4 used)
3. Solenoid valve (SV3)
4. Solenoid coil
5. Solenoid coil spacer
6. Nut
7. Solenoid valve (SV2)
8. Solenoid coil
9. Nut
10. Solenoid relief valve (SVRV)
11. S olenoid valve (SV1)
12. Relief valve (R7)
13. O--ring
14. Pilot piston (4 used)
15. O--ring
16. Hex plug (4 used)
Figure 77
FRONT
RIGHT
4
3
1
2
9
10
11
8
5
6
7
12
4
5
6
6
13
14
15
16
(33 N--m)
25 ft--lb
(27 N--m)
20 ft--lb
(27 N--m)
20 ft--lb
(101 N--m)
75 ft--lb
(27 N--m)
20 ft--lb
(33 N--m)
25 ft--lb
48 to 60 in--lb
(5.4 to 6.7 N--m)
48 to 60 in--lb
(5.4 to 6.7 N--m)
48 to 60 in--lb
(5.4 to 6.7 N--m)
NOTE: Theportsontheliftcontrolmanifoldaremarked
for easy identification of components. Example: P4 is
the gear pump P4 connection port and SV2 is the loca-
tionfor solenoid valve SV2. (See Hydraulic Schematics
to identify the function of the hydraulic lines and car-
tridge valves at each port location).