Toro Reelmaster 5210 - Lift Cylinder Service

Reelmaster 5010 SeriesHydraulic System (Rev. C) Page 4 -- 104
Lift Cylinder Service
1. Grease fitting
2. Shaft
3. Wiper
4. Head
5. U--Cup
6. Retaining ring
7. Back up washer
8. O--ring
9. Piston
10. Cap seal
11. O--ring
12. O--ring
13. Lock nut
14. Barrel
Figure 89
2
3
4
5
6
1
9
8
7
1
10
11
14
12
13
2
3
4
5
6
1
9
8
7
1
10
11
14
12
13
30 to 35 ft--lb
(41to47N--m)
NOTE: The front, center lift cylinder is shorter with less
stroke than the other lift cylinders which are identical.
Service procedures for all lift cylinders used on Reel-
master 5010 machines are the same.
Disassembly (Fig. 89)
1. Removeoilfromliftcylinderintoadrainpanbyslowly
pumping the cylinder shaft. Plug both ports and clean
the outside of the cylinder.
IMPORTANT: Prevent damage when clamping the
lift cylinder into a vise; clamp on the clevis end of
the barrel ONLY.
2. Mount lift cylinder securely in a vise by clamping on
the clevis end of the barrel. Use of a vise with soft jaws
is recommended.