Toro Reelmaster 5210 - Roller Service (Greasable Bearings with Retaining Ring)

Reelmaster 5010 Series
Cutting Units (Rev. C)
Page 7 -- 32
Roller Service (Greasable Bearings with Retaining Ring)
1. Roller tube (front Wiehle shown)
2. Roller shaft
3. Inner oil seal
4. Grease fitting
5. Ball bearing
6. Inner seal
7. Outer seal
8. Retaining ring
9. Outer oil seal
10. Roller washer
Figure 32
v
9
10
8
7
1
2
3
4
6
5
NOTE: Numerous front and rear rollers are available
for the Reelmaster cutting units. These rollers use one
oftwostylesofbearingandsealconfigurations.Thefirst
design has retaining rings that secure the bearings and
seals in the roller (Fig. 32). The second design uses a
bearing lock nut to retain bearings and seals (Fig. 34).