Toro Reelmaster 5210 - Preparing Reel for Grinding

Reelmaster 5010 Series
Cutting Units (Rev. C)
Page 7 -- 28
Preparing Reel for Grinding
NOTE: Beforegrindingacuttingreel,makesurethatall
cuttingunitcomponentsareingoodcondition.Depend-
ing on type of grinder used, faulty cutting unit compo-
nents can affect grinding results.
NOTE: When grinding, be careful to not overheat the
cutting reel blades. Remove small amounts of material
with each pass of the grinder.
1. Follow reel grinder manufacturer’s instructions to
grindcutting reelto Torospecifications(seeReelGrind-
ing Specifications chart to the right). Additional reel
grindinginformationcanbefound in ToroGeneral Ser-
vice Training Book, Reel Mower Basics (part no.
09168SL).
2. After completing the reel grinding process, adjust
cutting unit (see Cutting Unit Operator’s Manual).
Reel Grinding Specifications
Reel Diameter (New) 5.060 in (128.5 mm) for 5” reel
7.060 in (179.3 mm) for 7” reel
Service Limit -
Reel Diameter
4.500 in (114 mm) for 5”reel
6.600 in (168 mm) for 7” reel
Blade Relief A ngle 25
o
Blade Relief Angle Range 20
o
to 30
o
Blade Land Width 0.060 in (1.5 mm)
Blade Land Width Range 0.050 to 0.070 in (1.3 to 1.8 mm)
Service Limit -
Reel Diameter Taper
0.010 in (.25 mm) for 5” and 7” reel
Reel Diameter Taper = D
1
-- D
2
D
1
D
2
Blade Relief A ngle
Reel Diameter
Blade
Land
Width
Figure 29