Reelmaster 5010 Series
Cutting Units (Rev. C)
Page 7 -- 37
Disassembly (Fig. 40)
1. Positionmachineonacleanandlevelsurface,lower
cuttingunits,stopengine,engageparkingbrakeandre-
move key from the ignition switch.
2. To remove roller brush from brush shaft:
A. Remove the non--drive brush bearing housing
(item 30) from cutting unit.
B. Slide excluder seal from roller brush shaft.
C. RemovelocknutandJ--boltfrombothendsofthe
brush.
D. While rotating brush, slide brush from the s haft.
3. Disassemble rollerbrushcomponentsasnecessary
using Figures 40 as a guide.
Assembly (Fig. 40)
1. If brush was removed from shaft, slide brush onto
shaftwhilerotatingbrush.Securebrushtoshaftwithtwo
(2)J--boltsandlocknuts.MakesurethattheJ--boltsare
installed with the threaded portion on the outside of the
brush(Fig.41).Torquelocknutsfrom20to25in--lb(2.3
to 2.8 N--m).
2. If seals or bearings were removed from brush bear-
inghousings,install new components notingproperori-
entation as shown in Figure 42.
A. Pack bearings with grease before installation.
B. Press bearing into bearing housing so that bear-
ing contacts shoulder in housing bore.
C. Install grease seals so that seal lips are posi-
tioned toward the brush location. Press inner seals
into housing so that seal contacts bore shoulder.
Pressoutersealsintohousinguntilinnersealiscon-
tacted.
1. Roller brush shaft
2. J--bolt
3. Roller brush
4. Lock nut
Figure 41
1
2
3
4
20 to 25 in--lb
(2.3 to 2.8 N--m)
1. Bearing
2. Inner grease seal
3. Outer grease seal
4. Housing (non--driven)
5. Housing (driven)
Figure 42
2
2
1
1
4
5
3
3
Cutting
Units
To Next Page
Loading...
