Toro Reelmaster 5210 - Page 269

Reelmaster 5010 Series
Cutting Units (Rev. C)
Page 7 -- 39
5. Checkthatrollerbrushhaslightcontactwithrearroll-
er (Fig. 47). If contact is incorrect, brush operation will
be adversely affected. Also make sure that brush shaft
is parallel with rear roller.
6. Lubricate grease fittings on brush housings until
grease purges past inboard s eals. Wipe excess grease
from seals and fittings.
1. Driven pulley
2. Drive pulley
3. Straight edge
Figure 45
2
1
3
Figure 46
1. Rear roller brush
2. Rear roller
3. Light contact
Figure 47
2
1
3
Cutting
Units